3.6.3 Connection of the Controller and Primary Power

Check whether the power has been removed from the primary power and breaker (CB). In the case of a Hi6-S** controller, insert the power cable through the power inlet and then connect it to the breaker (NFB). At this time, use a terminal receptacle of an appropriate size for the end side of the primary power supply cable.

Figure 3.8 Primary Power Connection Part of Hi6-S00/S10/S20 Controller
Figure 3.9 Primary Power Connection Part of Hi6-S01/S11/S21 Controller
Previous3.6.2 Connection of the Manipulator and ControllerNext3.6.3.1 Power Requirements

Last updated