8.7 R212 for Presetting the Servo Gun Moving Electrode Wear Volume
Previous8.6 R211 for Setting the Servo Gun Squeeze ForceNext8.8 R213 for Presetting the Servo Gun Fixed Electrode Wear Volume
Last updated
Was this helpful?
Last updated
Was this helpful?
You can manually set the servo gun moving electrode wear volume.
After inputting 212 in the favorites window, touch the [OK] button or press the <enter> key.
After inputting the moving electrode wear volume, touch the [OK] button or press the <enter> key.
It requires your attention that if the setting value is set larger or smaller than the actual wear volume of the electrode, it may cause mismatching of the squeeze force or interference with the workpiece.
R212 code cannot be used during the startup of the robot.
The spot gun number can be set only in the spot welding environment ([Spot Welding] item in the [Set Up > 5: Initialize> 3: Usage Setting] menu is set as enable).
For details on the manual setting of the servo gun moving electrode wear volume, refer to the “Hi6 Controller Spot Welding Function Manual.”
