7.3.2.1 Input Signal Attribute

You can set the logic and name for a general input signal.

  1. Touch the [2: Control Parameter > 2: Input/Output Signal Setting > 1: Input Signal Attribute] menu.

  2. Check and set the general input signal list, and then touch the [OK] button.

  • [Append]: You can add a new general input signal to the list.

  • [Delete]: You can delete the general input signal from the list.

Previous7.3.2 Input/Output Signal SettingNext7.3.2.2 Output Signal Attribute

Last updated

Was this helpful?