3.3.2 Analog I/O setting
Last updated
Was this helpful?
Last updated
Was this helpful?
Select the [Configure] button > [4: Application parameter > 21: Cobot Setup > 3: Cobot I/O setting > 2: SCM Analog I/O].
Set the I/O voltage, current, gain, and offset, and click the [OK] button.
[Analog I/O range]: Select the voltage or current range of the analog I/O channel.
[Analog I/O gain]: Set the analog I/O gain (unit: %).
[Analog I/O offset]: Set the analog I/O offset (unit: mV or uA).
The specified values of voltage and current will apply to the system after the controller is rebooted.
