6.6 Public Input

Touch [public Input] in the panel selection window. Then, the public input signal window will appear.

You can check the status of public input signals that are inputted through the CNIN connector of the I/O board in the controller.

Figure 39 Public Input Signal – ON/OFF Status (Left) / Value Status (Right)

No.	Description
	Displays the status of general input signals General input signals designated as the system’s basic specifications or assigned by the user will be displayed in bold. The signals currently being inputted will be displayed in yellow.
	[FB0]: You can select the FB block to monitor by touching the drop-down menu (FB0 - FB15). You can configure up to 16 I/O blocks, and 960 points of signals can be monitored in [ATTR.-APPLIED]: You can check the checkbox to perform the setting in a way that the physical input values are to be displayed before passing through the positive/negative logic attributes. The basic setting (unchecked) is that the input logic value after passing through the positive/negative logic attributes will be displayed. [ON/OFF]/[Value]: You can change the signal display mode by touching the radio button.

• In the case of using signals, such as fieldbus signals, by mapping them using an embedded PLC, the On/Off status of the input signals may appear differently.

• The flow of the input signals is as follows.